User Instructions for iCage™

Instructions for iWRAPr™ Use

  1. Turn iPod® off and clean thoroughly.
  2. Slide iWRAPr over iPod so that the seam of the iWRAPr is located on the back of the iPod. Center iPod in the iWRAPr.
  3. Place iPod screen side down on a flat surface. Using a household blow-dryer, set the temperature on the HIGHEST heat setting and HIGHEST fan setting.
  4. Apply heat evenly in small circular motions across the back of the iPod for approximately 10–15 seconds. Turn over and repeat process (for BEST RESULTS the blow-dryer should be as close to the surface of the iWRAPr as possible without touching it). Be sure to apply heat to the corners and edges. Repeat process to perfect iWRAPr application.
    User Instructions
 User Instructions
User Instructions

Instructions for Inserting iPod

Slide iPod into cage frame as shown, insuring access to all ports. Attach additional soft felt strips if needed to insure a tight fit. (For 80GB & 120GB iPods, see Instructions for Adding Rubber Spacers for 80GB & 120GB iPod for additional instructions).
User Instructions

To Set the Combination for your iPod iCage: Lock is preset to initially open at 0–0–0.

To set your own combination:

  1. User InstructionsWith dials at 0–0–0, push in the shackle.
  2. With shackle pushed in, set your new combination.
  3. Release shackle and scramble wheels to lock.
  4. Be sure to record your secret combination.

To Lock Down: Wrap cable around fixed object and secure loop into shackle of lock.
User Instructions

Instructions for Inserting Nano

For Gen I & Gen II iPods: remove plastic insert.
User Instructions

Slide iPod Nano into cage frame as shown, insuring access to all ports.
User Instructions

To Set the Combination for your Nano iCage: Lock is preset to initially open at 0–0–0.

To set your own combination:

  1. User InstructionsWith dials at 0–0–0, pull out shackle.
  2. Turn shackle counter clockwise 90° (1/4 turn) and press it down.
  3. Continue pressing shackle and turn another 90° (1/4 turn).
  4. Set the dials to your own combination.
  5. Turn shackle clockwise back to the original 90° position. Lift and return shackle to closed position.

To Lock Down: Wrap cable around fixed object and secure loop into shackle of lock.
User Instructions

Instructions for Adding Rubber Spacers for 80GB & 120GB iPod

To insure a secure fit for your 80GB or 120GB iPod, attach rubber spacers as follows:

  1. Locate the two hard rubber spacers.
    User Instructions
  2. Peel adhesive backing off rubber spacers.
  3. Apply rubber spacers opposite felt strips.
    User Instructions
  4. Slide iPod into cage frame as shown, insuring access to all ports. (For maximum security, make sure rubber strips are in front of iPod screen side.
    User Instructions